Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
428 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show ipv6 mld snooping [Vlan <vlan id>]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
If you specify VLAN, the configuration of all VLANs is displayed.
The information about MLD snooping is displayed.
You enable MLD snooping with the ipv6 mld snooping command.
show ipv6 mld snooping forwarding-database
Description
This command shows the multicast forwarding entries for all or a selected VLAN.
● MLD snooping must be enabled globally and in the VLANs.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ipv6 mld snooping forwarding-database [Vlan <vlan id>]
The parameters have the following meaning
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
If you specify VLAN, the configuration of all VLANs is displayed.
To Next Page
Loading...
