Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
457
9.2.3.5
no area range
Description
With this command, you delete the address range.
Note
This command i
s available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <AreaId> range <Network> <Mask>
The parameters have the following meaning:
Parameter
Description
Range of values / note
AreaId
Area-ID specify an ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
Network
IP address of the address range
specify the IP address
Mask
Subnet mask of the address range
specify the subnet mask.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The address range is deleted.
Further notes
You create address ranges with the area range command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English