Siemens SCALANCE XR-500

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
585
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> preempt
The parameter has the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
Result
The function is disabled.
Further notes
You configure a VRRP3 interface with the interface command.
You assign IP addresses to a virtual router with the
vrrp associated -ip command.
You enable the function with the
vrrp preempt command.
You can display the status of the function with the
show vrrp3 interface - vrid or with the
show vrrp3 interface command.
9.5.5.9
vrrp primary-ip
Description
With this command, you specify the primary IP address specified with the VRRP3 packets as
the source address.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#