Siemens SCALANCE XR-500

Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
410 Configuration Manual, 11/2015, C79000-G8976-C252-10
8.4.5.5
no ring-redundancy standby
Description
With this command, you disable the standby function.
Requirement
● HRP is enabled
● You are in the Global configuration mode.
The command prompt is:
cli(config)#
Syntax
Call the command without parameters:
no ring-redundancy standby
Result
The standby function is disabled.
Further notes
You enable the setting with the ring-redundancy standby command.
You can display the status of this function and other information with the
show ring-
redundancy
command.
8.4.6
Commands in the redundancy configuration mode
This section describes commands that you can call up in the Redundancy Configuration
mode.
In the Global Configuration mode, enter the
ring-redundancy configuration command to
change to this mode.
● If you exit the Redundancy Configuration mode with the
exit command, you return to the
Global Configuration mode.
● If you exit the Redundancy Configuration mode with the
end command, you return to the
Privileged EXEC mode.