Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
394 Configuration Manual, 11/2015, C79000-G8976-C252-10
show ip igmp snooping switch-ip
Description
This command shows the IP address of the source for IGMP snooping.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip igmp snooping switch-ip
The IP address is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
ip igmp snooping version
Description
This command specifies which version of IGMP the device will use. When shipped, the
device uses IGMPv3.
Note
There is no separate show comman
d to display the version of IGMP used by the device.
This information is shown when you enter the
show ip igmp snooping command in the User
EXEC mode or in the Privileged EXEC mode.
To Next Page
Loading...
Need help?
General