Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
746 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
no dot1x mac-auth
MAC authentication is disabled for the device.
You enable the function with the dot1x mac-auth command.
You display this setting and other information with the
show dot1x mac-auth mac-info
command.
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
dot1x guest-vlan
Description
With this command, you enable the guest VLAN function for a port.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
dot1x guest-vlan
To Next Page
Loading...
Need help?
General