Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
178 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
interface range
(
{<interface-type> <0/a-b,0/c,...>}
{vlan <vlan-id(1-4094)> - <vlan-id(2-4094)>}
)
The parameters have the following meaning:
Enter a valid interface.
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Number of the addressed VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you want to address several VLANs with this command, you must insert a blank before
and after the hyphen, for example
interface range vlan 5 - 10.
The interfaces or interfaces of VLANs were put together to form an interface range.
The command prompt is as follows:
cli(config-if-vlan-range)#
The configuration commands you enter in a mode apply to all interfaces of this area.
With the no interface range command, you remove VLANs from this range or break it up.
no interface range
Description
With this command, you remove the interfaces or interfaces of VLANs from the interface
range or break it up if you first remove all previously added interfaces.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General