Configuration
3.5 PoE
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
128 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
poe type <string>
The parameters have the following meaning:
Description of a connected device
The description of the connected device has been specified.
With this command, you delete the description for a connected device.
You are in the Interface Configuration mode of a PoE interface.
The command prompt is as follows:
cli(config-if-Gi$-$)#
The placeholders $-$ stand for the numbering of the interface.
Call the command without parameters:
no poe type
The description of the corresponding device is deleted.
With this command, you specify the priority of the power supply for an interface.
To Next Page
Loading...
Need help?
General