Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
516 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.3.3.5
no area range
Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no area <Area-ID> range
<IPv6-Prefix> / <Prefix-Length>
[{
advertise | not-advertise
}]
[
cost <cost>
]
The parameters have the following meaning:
Parameter
Description
Range of values / note
AreaID
Area ID Specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
0.0.0.0 = backbone area
IPv6-Prefix
IPv6 address
Enter a valid IPv6 address
Prefix-Length
Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
advertise
The address range is advertised outside the rang-
es.
-
not-advertise
The address range is not advertised to the outside.
-
cost
Keyword for the costs
-
value
Costs for the OSPF interface
1 ... 65535
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English