Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
622 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 rip
Result
RIPng routing is enabled.
Further notes
You display this setting and other information with the show ipv6 rip command.
You disable RIP routing with the
no ipv6 rip command.
9.7.4.4
no ipv6 rip
Description
This command disables RIPng routing on the interface.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ipv6 rip
Result
RIPng routing is enabled.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English