Siemens SCALANCE XR-500

Functions specific to SCALANCE
4.3 Panel button
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
140 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call the command without parameter assignment:
no panel-button control-factory-defaults
Result
The function of the "SELECT/SET" button for restarting with factory settings is enabled or
disabled.
Further notes
You enable this function with the panel-button control-factory-defaults command.
4.3.1.3
set panel-button control-faultmask
Description
With this command, you enable or disable the following function of the "SELECT/SET"
button:
● If display mode D "fault mask" is displayed and the button is pressed for 5 - 12 seconds,
the fault mask is set.
This function corresponds to calling the
power and link down commands.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
set panel-button control-faultmask{enable|disable}
The parameters have the following meaning:
Parameter
Description
Range of values / note
enable
enabl
es the function for setting the fault
mask
Default: enabled
disable
disables the function for setting the
fault mask
-