Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
543
ipv6 ospf priority
Description
With this command, you specify the router priority. The designated router is identified based
on the priority.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 ospf priority <priority>
The parameter has the following meaning:
Priority 0 ... 255
The priority is specified.
You enable OSPFv3 routing with the ipv6 router ospf command.
You reset the priority to the default with the
no ipv6 ospf priority command.
You display the configuration with the
show ipv6 ospf interface command.
To Next Page
Loading...
Need help?
General