Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
95
Multicast frames are blocked.
You disable the blocking of multicast frames with the no multicast-block command.
no multicast-block
Description
With this command, you disable the blocking of multicast frames on an interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameter assignment:
no multicast-block
The blocking of multicast frames is disabled.
You enable the blocking of multicast frames with the mulitcast-block command.
With this command, you enable autonegotiation of connection parameters on an interface.
Autonegotiation must be set for every interface of connected interfaces.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
To Next Page
Loading...
Need help?
General