Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
749
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
dot1x guest
-vlan reset [mac <aa:aa:aa:
aa:aa:aa>] The parameter has the following meaning:
Keyword for the MAC address
MAC address to be removed from the
The specified MAC address or all MAC addresses are no longer assigned to the guest
VLAN.
set dot1x guest-vlan mac-addr count
Description
With this command, you specify how many AC addresses can be authenticated on the port
at the same time.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
set dot1x guest-vlan mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Maximum number of devices
To Next Page
Loading...
Need help?
General