Siemens SCALANCE XR-500

Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
317
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameters:
ipv6 dhcp client reconfig-accept
Result
The option "DHCP reconfig-accept" is enabled.
Further notes
You disable the option with the no ipv6 dhcp client reconfig-accept command.
7.4.2.7
no ipv6 dhcp client reconfig-accept
Description
With this command, you enable the "DHCP reconfig-accept" option.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameters:
no ipv6 dhcp client reconfig-accept