Layer 2 management protocols
8.6 Multicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
422 Configuration Manual, 11/2015, C79000-G8976-C252-10
This section describes commands with which you display various settings.
show multicast-block config
Description
This command shows the multicast blocking settings for ports.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Keyword for a port description
Enter a valid interface
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If no parameters are specified, the settings for all ports are displayed.
The multicast blocking settings for ports are displayed.
show mac-address-table dynamic multicast
Description
This command shows the table with the dynamic multicast MAC addresses assigned by the
device.
To Next Page
Loading...
Need help?
General