Siemens SCALANCE XR-500

Functions specific to SCALANCE
4.1 PLUG
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
134 Configuration Manual, 11/2015, C79000-G8976-C252-10
4.1.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
4.1.2.1
plug
Description
With this command, you change to the Plug Configuration mode.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
plug
Result
You are now in the Plug Configuration mode.
The command prompt is as follows:
cli(config-plug)#
Further notes
You exit the Plug Configuration mode with the end or exit command.