Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
313
The HMAC-MD5 function is configured.
You configure the interface as a router port with the no switchport command.
You enable the function DHCPv6 client with the
ipv6 address dhcp command.
You display the setting with the
show ipv6 dhcp interface command.
ipv6 dhcp client information refresh minimum
Description
With this command, you configure the interval after which the DHCP client refreshes the
configuration parameters.
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 dhcp client information refresh minimum <seconds value(600-4294967295)>
The parameter has the following meaning:
seconds value Length of the interval in seconds 600 ... 4294967295
Default: 4294967295 (24 hours)
The interval is specified. When the time elapses, the DHCPv6 client sends an information
request message to refresh the configuration parameters.
To Next Page
Loading...
Need help?
General