Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
444 Configuration Manual, 11/2015, C79000-G8976-C252-10
The information on the selected LSA type is displayed.
show ip ospf border-routers
Description
This command shows the routes to the area border routers and to the AS boundary routers.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip ospf border-routers
The routes are displayed.
show ip ospf interface
Description
This command shows the information on the OSPF interface.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General