Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
197
no switchport pvid
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no switchport pvid
The setting is reset to the default value.
You configure the setting with the switchport pvid command.
You configure the VLAN ID with the
switchport access vlan command.
You can display the status of this function and other information with the
show vlan port
config
command.
tia interface
Description
With this command, you enable or disable the property TIA interface. The interface can be
used for PNIO.
To Next Page
Loading...
Need help?
General