Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
208 Configuration Manual, 11/2015, C79000-G8976-C252-10
port-channel load-balance
Description
With this command, you configure the load balancing policy for the interconnected ports of
the previously defined port channels.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
port-channel load-balance
{mac-src-dst | ip-mac-src-dst}
[<port-channel-index(1-8)>]
The parameters have the following meaning:
Load balancing is based on the MAC
addresses of the sources and destina-
Default: enabled
Load balancing is based on the IP and
MAC addresses of the sources and
-
Number of the port channel
If you do not enter a value for port-channel-index, the setting is used for all port channels.
The load balancing policy is set.
You can reset the setting for the load balancing policy to the default with the no port-channel
load-balance
command.
You can display the status of this function and other settings with the
show etherchannel
command.
To Next Page
Loading...
Need help?
General