Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
522 Configuration Manual, 11/2015, C79000-G8976-C252-10
no ASBR Router
Description
With this command, you disable the autonomous system boundary router.
Note
This command is available only with layer
3.
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Call the command without parameters:
no ASBR Router
The autonomous system boundary router is disabled.
You enable the autonomous system boundary router with the ASBR Router command.
You can display the status of this function and other information with the
show ipv6 ospf
command.
With this command, you create an entry in the host table and assign an area ID and / or a
metric to it.
Note
This command is available only with layer 3.
To Next Page
Loading...
Need help?
General