Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
523
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Call up the command with the following parameters:
host <IPv6-Address>
{
metric <cost>
} [
area-id {<AreaID>}
]
The parameters have the following meaning:
IPv6 address prefix of the host
Enter a valid IPv6 address
Keyword for the metric of the external
-
Keyword for the area ID -
Area ID Specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The entry is configured in the host table.
You remove an entry with the no host command.
You display the host table with the
show ipv6 ospf host command.
To Next Page
Loading...
Need help?
General