Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
392 Configuration Manual, 11/2015, C79000-G8976-C252-10
show ip igmp snooping
Description
This command shows information about IGMP snooping for all or a selected VLAN.
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global
configuration mode.
The command prompt is as follows:
cli> or cli# or cli(config)#
Call up the command with the following parameters:
show ip igmp snooping [Vlan<vlan id]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The information about IGMP snooping is displayed.
show ip igmp snooping forwarding-database
Description
This command shows the multicast forwarding entries for all or a selected VLAN.
● IGMP snooping is enabled on the device
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is:
cli> or cli#
To Next Page
Loading...
Need help?
General