Siemens SCALANCE XR-500 - Vrrp Virtual-Ping; No Vrrp Virtual-Ping

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
555
9.4.3.3
vrrp virtual-ping
Description
With this command, you enable pings to virtual addresses.
Requirement
● The Router configuration mode is enabed.
● You are in the VRRP Router configuration mode.
The command prompt is:
cli(config-vrrp)#
Syntax
Call the command without parameters:
vrrp virtual-ping
Result
The function for pings to virtual addresses is enabled.
Further notes
You disable the setting with the no vrrp virtual-ping command.
You display the status of this function and other information in Privileged EXEC mode with
the
show vrrp command.
9.4.3.4
no vrrp virtual-ping
Description
With this command, you disable pings to virtual addresses.
Requirement
● The Router configuration mode is enabed.
● You are in the VRRP Router configuration mode.
The command prompt is:
cli(config-vrrp)#
Syntax
Call the command without parameters:
no vrrp virtual-ping