Siemens SCALANCE XR-500 Configuration Manual

Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
74 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
ping [ip]<destination-address>
[size<byte(0-2080)>]
[count<packet_count(1-10)>]
[timeout<seconds(1-100)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
ip
Uses an IPv4 address
-
destination-address
Address of the called node Enter a valid IPv4 address or a
valid host name.
size
Keyword for the size of the packets to
be transferred
-
byte
Keyword for the size of the packets in
bytes
0 … 2080
Default: 32
count
Keyword for the number of packets to
be requested
-
packet_count
Number of packets 1 … 10
Default: 3
timeout
Response wait time
If this time expires, the request is re-
ported as "timed out".
-
seconds
Time to the timeout in seconds 1 … 100
Default: 1
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default values are used.
Result
The messages relating to the response of the called node are displayed.
3.1.10
ping ipv6
Description
With this command, you request a response from a device in the network. This allows you to
check whether or not another node is reachable.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English