Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
615
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Call up the command with the following parameters:
distribute prefix <ip6_addr> {in | out}
The parameters have the following meaning:
enter a valid IPv6 address
Incoming routing information is filtered. -
Outgoing routing information is filtered.
Filtering is enabled.
You disable filtering with the no distribute prefix command.
You display the configured filters with the
show ipv6 rip filter command.
no distribute prefix
Description
This command disables the filtering of the routing information according to an IPv6 address
for incoming or outgoing routing information.
Note
This command is available only with layer 3.
You are in the RIPng router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
To Next Page
Loading...
Need help?
General