Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
486 Configuration Manual, 11/2015, C79000-G8976-C252-10
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call up the command with the following parameters:
ip ospf cost <cost (1-65535)>
The parameter has the following meaning:
Costs for the OSPF interface
The costs are specified.
You delete the costs with the no ip ospf cost command.
You show the configuration of the OSPF interface with the
show ip ospf interface
command.
no ip ospf cost
Description
With this command, you delete the costs.
Note
This command is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
To Next Page
Loading...
Need help?
General