Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
514 Configuration Manual, 11/2015, C79000-G8976-C252-10
The address range is configured.
You delete the address range with the no area range command.
You configure the area with the
area command.
You can display the status of this function and other information with the
show ipv6 ospf -
area-range / summary-address
command.
area range - ipv6prefix and prefix length
Description
With this command, you assign an area ID an address range. The address range is used to
group the routes within OSPFv3.
Note
This command is available only with layer 3.
● The area is of the type NSSA
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
To Next Page
Loading...
Need help?
General