Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
510 Configuration Manual, 11/2015, C79000-G8976-C252-10
Routing with OSPFv3 is disabled.
You enable routing with OSPFv3 with the ipv6 router ospf command.
Commands in the Router configuration mode
This section describes commands that you can call up in the Router Configuration mode.
In the global configuration mode, enter the
ipv6 router ospf command to change to this
mode.
Commands relating to other topics that can be called in the Global Configuration mode can
be found in the relevant sections.
● If you exit the Router Configuration mode with the
exit command, you return to the
Global Configuration mode.
● If you exit the Router Configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you configure areas of the type NSSA (not-so-stubby-area) or stub.
Note
This command is available only with layer 3.
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
To Next Page
Loading...
Need help?
General