Siemens SCALANCE XR-500 - No Vrrp Virtual-Ping

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
576 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
You are in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
Syntax
Call the command without parameter assignment:
vrrp virtual-ping
Result
The ping function to virtual IPv4 addresses is enabled.
Further notes
You disable the ping function for virtual IPv4 addresses with the no vrrp virtual-ping
command.
You display the status and the configuration of the VRRP3 interfaces with the
show vrrp3
interface - vrid
command.
9.5.4.4
no vrrp virtual-ping
Description
With this command, you disable pings to virtual IPv4 addresses.
Requirement
You are in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
Syntax
Call the command without parameter assignment:
no vrrp virtual-ping
Result
The function for pings to virtual IPv4 addresses is disabled.