Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
507
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ipv6 ospf {area-range|summary-prefix}
The parameters have the following meaning:
Grouped area range.
The address range is created with the "area-range"
-
Grouped address range for OSPFv3
The address range is created with the "summary-
-
The grouped address ranges are displayed.
show ipv6 ospf request-list / retrans-list
Description
This command shows a list with LSAs.
Note
This command is availa
ble only with layer 3.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General