Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
479
summary-address
Description
With this command, you assign an area ID an address range. The address range is used to
group the external routes.
Note
This command is available only with layer 3.
● The router is an area border router (ABR)
● You are in the OSPF Router configuration mode.
The command prompt is:
cli(config-ospf)#
To Next Page
Loading...
