Siemens SCALANCE XR-500 - Page 480

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
480 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
summary-address <Network> <Mask> <AreaId>
[{
allowAll | denyAll | advertise |not-advertise
}]
[
Translation
{enabled | disabled}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Network
IP address of the address range
specify the IP address
Mask
Subnet mask of the address range specify the subnet mask.
AreaId
Area-ID specify a valid ID.
x.x.x.x
x = 255
0.0.0.0 = backbone area
allowAll
The backbone area generates an LSA
message of Type 5 for the address
range.
LSA messages of Type 7 also gener-
ated for this address range in the con-
nected NSSAs.
-
denyAll
No LSA is of Type 5 or Type 7 is gen-
erated for the address range.
-
advertise
The address range is advertised out-
side the areas.
In the backbone area, the router gen-
erates an LSA message of Type 5.
If the Area ID is not 0.0.0.0, the router
generates an LSA message of Type 7
in an NSSA
-
not-advertise
No LSA messages of Type 5 are gen-
erated in the backbone area. The
NSSAs connected to the backbone
area generate LSA messages of Type
7. The other areas do not generate any
LSA
-
Translation
Keyword for the P bit. The P bit indi-
cates to the NSSA-ABR whether the
LSA messag
e of Type 7 is translated to
Type 5.
-
enabled
P bit = 1.
LSA message is translated
-
disabled
P bit = 0.
LSA message is not translated
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".