Siemens SCALANCE XR-500

Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
748 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
dot1x guest-vlan vlan-id <vlan-id (1 - 4096)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for the VLAN ID
-
- VLAN ID 1 - 4096
Result
The guest VLAN ID is assigned to the port.
11.7.3.4
no dot1x guest-vlan vlan-id
Description
With this command, the guest VLAN ID is reset to the default value 1.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x guest-vlan vlan-id
Result
The ID of the guest VLAN has the value 1.
11.7.3.5
dot1x guest-vlan reset
Description
This command removes MAC addresses from the guest VLAN. If you specify a MAC
address, only this MAC address is removed from the guest VLAN. If you use this command
without parameters, all MAC addresses are removed from the guest VLAN.