Siemens SCALANCE XR-500

Network protocols
7.7 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
345
7.7.1.9
show snmp targetaddr
Description
This command shows the configured SNMP target addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp targetaddr
Result
The configured SNMP target addresses are displayed.
7.7.1.10
show snmp targetparam
Description
This command shows the configured SNMP target parameters.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp targetparam
Result
The configured SNMP target parameters are displayed.