Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
415
You disable the setting with the no standby port command.
You display the status of this function and other information
show ring-redundancy.
no standby port
Description
With this command, disable the port for a standby connection on a device.
You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#
Call up the command with the following parameters:
no standby port [<interface-type><interface-id>}
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The ports for a standby connection are disabled.
You enable the setting with the standby port command.
You display the status of this function and other information
show ring-redundancy.
To Next Page
Loading...
Need help?
General