Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
573
no router vrrp3
Description
With this command, you disable routing with VRRPv3.
Note
This command is available only with layer 3.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
no router vrrp3
Routing with VRRPv3 is disabled.
You enable routing with VRRPv3 with the router vrrp3 command.
Commands in the VRRP3 Router configuration mode
This section describes commands that you can call up in the VRRP3 Router configuration
mode.
In the Global configuration mode, enter the
router vrrp3 command to change to this mode.
● If you exit the VRRP3 Router configuration mode with the
exit command, you return to
the Global configuration mode.
● If you exit the VRRP3 Router configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General