Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
636 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
match metric-type {inter-area | intra-area | type-1-external | type-2-external }
The parameters have the following meaning:
Routes learnt from different areas
Routes that originate from the same area -
Routes whose path costs (metric) are made up from the
external path costs and the patch costs to the ASBR
-
Routes with only external path costs (metric) -
The filter for the type of the metric is created.
You delete the filter for the type of the metric with the no match metric-type command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
no match metric-type
Description
With this command, you delete the filter for the type of the metric.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
To Next Page
Loading...
Need help?
General