Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
459
With this command, you configure areas of the type Stub.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Call up the command with the following parameters:
area <area-id> stub [ no-summary ]
The parameters have the following meaning:
Area-ID specify a valid ID.
x.x.x.x
x = 0 ... 255
The router does not send or receive a
--
The area of the type Stub is configured.
You change the type of the area with the no area command.
To Next Page
Loading...
Need help?
General