Siemens SCALANCE XR-500 - Standby Connection-Name; No Standby Connection-Name

Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
412 Configuration Manual, 11/2015, C79000-G8976-C252-10
8.4.6.2
standby connection-name
Description
With this command, you assign a name to the standby connection on the device.
Requirement
You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call up the command with the following parameters:
standby connection-name <string(32)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
<string(32)>
Name of the connection
max. 32 characters
Result
The standby connection is assigned a name.
8.4.6.3
no standby connection-name
Description
With this command, you delete the name of a standby connection.
Requirement
You are in the Redundancy Configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call the command without parameters:
no standby connection-name