Load control
10.5 Service classes
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
670 Configuration Manual, 11/2015, C79000-G8976-C252-10
The list for all ports with the corresponding Trust mode is displayed.
Commands in the Global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you change to the QOS configuration mode.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
qos
You are now in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
You exit the QOS configuration modewith the command end or exit.
To Next Page
Loading...
Need help?
General