Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
332 Configuration Manual, 11/2015, C79000-G8976-C252-10
You configure the device ID with the ip dhcp relay remote-id command.
You display the IP addresses with the
show dhcp server command.
You display the settings with the
show ip dhcp relay information command.
DHCPv6 Relay Agent (IPv6)
This section describes commands for the DHCPv6 Relay Agent.
This section describes commands with which you display various settings.
show ipv6 dhcp relay statistics
Description
This command displays the DHCPv6 relay agent settings for all or for a selected interface.
● The DHCPv6 relay agent is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ipv6 dhcp relay statistics [interface {vlan <vlan-id(1-4094)> | <interface-type>
<interface-id>} ]
The parameters have the following meaning:
Shows that an interface description follows
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter, the entries are displayed for all available interfaces.
To Next Page
Loading...
Need help?
General