Diagnostics
12.2 FMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
782 Configuration Manual, 11/2015, C79000-G8976-C252-10
● To be able to use the fiber monitoring function, enable LLDP. The fiber monitoring
information is appended to the LLDP packets.
● You can only use fiber monitoring with transceivers capable of diagnostics. Note the
documentation of the devices.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
fmp
Default: enabled
Fiber monitoring is enabled.
You disable this function with the no fmp command.
You display the status of this function and other information with the
show fmp stauts and
show fmp limit commands.
You define the limit values with the
fmp power-loss and fmp rx-power commands.
With this command, you disable fiber monitoring.
You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
no fmp
Default: enabled
To Next Page
Loading...
Need help?
General