Siemens SCALANCE XR-500 - No Interface; Vrrp Virtual-Ping

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
575
9.5.4.2
no interface
Description
With this command, you delete a VRRP3 interface.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP3 Router configuration mode.
The command prompt is as follows:
cli (config-vrrp-v3)#
Syntax
Call up the command with the following parameters:
no interface vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 … 4094
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The VRRP3 interface has been deleted.
Further notes
You configure a VRRP3 interface with the interface command.
You display the status and the configuration of the VRRP3 interface with the
show vrrp3
interface
show vrrp3 interface - vrid command.
9.5.4.3
vrrp virtual-ping
Description
With this command, you enable the ping function to virtual IPv4 addresses.