Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
586 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
vrrp <vrid(1-255)> primary-ip [{ ipv4 <ip_addr> | ipv6 <ip6_addr> }]
The parameters have the following meaning:
Keyword for IPv4 address -
Enter a valid IPv4 address.
Enter a valid IPv6 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The primary IP address is specified.
You configure a VRRP3 interface with the interface command.
You remove the primary IP address with the
no vrrp pirmary-ip command.
You show the configuration of the virtual router with the
show vrrp3 interface - vrid
command.
no vrrp primary-ip
Description
With this command, you remove a primary IP address from the virtual router.
Note
This command is available only with layer 3.
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
To Next Page
Loading...
Need help?
General