Siemens SCALANCE XR-500

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
191
6.1.3.6
no switchport access vlan
Description
With this command, you reset the setting for the port VLAN identifier (PVID) for an interface
to the default value.
The default value is 1.
Requirement
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport access vlan
Result
The setting is reset to the default value.
Further notes
You configure the setting with the switchport access vlan command.
You can display the status of this function and other information with the
show vlan port
config
command.
6.1.3.7
switchport map protocols-group
Description
With this command, you assign the protocol group and a VLAN to an interface.
Requirement
● The protocol group is configured.
● You are in the Interface configuration mode
.The command prompt is:
cli(config-if-$$$)#