Siemens SCALANCE XR-500

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
489
9.2.4.9
ip ospf hello-interval
Description
With his command, you specify the interval between two Hello packets.
Note
This command
is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf hello-interval <seconds (1 - 65535)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
seconds
Interval in seconds
0 ... 65535
Result
The interval is specified.
Further notes
You delete the interval with the no ip ospf hello-interval command.
You show the configuration of the OSPF interface with the
show ip ospf interface
command.