Siemens SCALANCE XR-500

Load control
10.2 Static MAC filtering
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
658 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static multicast<aa:aa:aa:aa:aa:aa>
vlan<vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
aa:aa:aa:aa:aa:aa
MAC address of the interface
-
vlan
Keyword for the number of a VLAN
connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show mac-address-table static multicast command, you display the list of
configured entries.
With the
mac-address-table static multicast command, you create an entry.
10.2.1.4
mac-address-table static unicast
Description
With this command, you generate a static unicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#