Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
560 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> preempt [delay minimum <value(0-30)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
delay minimum
Keyword for a period of time -
value
Time after which the new Master router
sends its VRRP packet.
0 ... 30
Result
The function is enabled.
Further notes
You enable routing with VRRP with the router vrrp command.
You disable the function with the
no vrrp preempt command.
You can display the status of the function with the
show vrrp interface - vrid or with the
show vrrp interface command.
9.4.4.5
no vrrp preempt
Description
With this command, you specify that a router cannot take over the master role from a router
with lower priority. The master role is adopted only if the current master router fails.
Note
This command is available only with layer 3
.
Requirement
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English